facebook

ANSERGLOB interior «ЕКО+»

Advantages

  • Permeable
  • Ecologically friendly
  • For interior substrates
  • High covering capacity
  • Resistant to dry wiping

Technical data

Gloss Matte
Density 1,5 g/cm3
Spreading rate Approx. 150 g/cm2
Time before overcoating 1-2 hours
Surface temperature from +5°С to +30°С
Exploitation temperature from -30°С to +80°
Interior acrylic paint ANSERGLOB ECO+ is used for high quality coating interior walls and ceilings in-doors. It is applied on any mineral substrates as concrete, brickwork, cement and cement-lime mortars (hu-midity less than 4%) gypsum mortars and drywall (humidity less than 1 %) etc, and on the organic substrates (plywood, fiberboard, particleboard, OSB, wallpapers). It is suitable for multi-coating. Paint is resistant to dry scrubbing.
The surface preparation is realized according to State Standard of Ukraine (DSTU N B A.3.1-23:2013) and State Building Codes of Ukraine (DBN В.2.6-22-2001). Surface must be structurally sound, clean, dry and free from dust, lime, grease, dirt, oil or emulsion paints. While repair works and before applying the paint fragile areas of the substrate should be thoroughly removed. The cracks into the substrate must be filled up with the one of the ANSERGLOB products (for an example, small cracks is filled up by the ANSERGLOB BCT 25 or BCT 27). Before applied the paint solid and dense mineral substrates as brick-work, concrete beds, cement-sand and cement-lime mortars, gypsum mortars and wooden surfaces should be previously treated by the one of deep penetrating primers ANSERGLOB. Weak mineral substrates should be cleaned till solid layer. The coatings based on synthetic paints must be removed and treated by the one of deep penetrating primers ANSERGLOB. Interior acrylic paint ANSERGLOB ECO+ is applied after 4 hours after grouting by primer.
Before applied interior acrylic paint ANSERGLOB ECO+ must be well mixed by the drill on low revs. The paint is applied on the surface in one or two layers by the brush, block brush, roller (felt, foam rubber) or sprayer. Application on the same surface must be provided continuously according to the rule "wet on wet". Paint can be diluted by water (but no more then 5 % from paint weight) for the first layer of coating. It is not recommended to dilute paint by water for the second layer of coating and the next ones. Depending on the temperature and humidity conditions second layer of coating is applied after 1-2 hours after the first one. When applied avoid the drying of the paint and wash the hands and tools by water.

Note:Application should be complied at temperature above +5 °С and below +30 °С. All the mentioned recom-mendations are effective at temperature of +20 °С and air humidity of 60 %. Under the other conditions dry-ing time may be changed. Do not use for substrates constantly exposed to stress (floors). For identity of the substrate color it is recommended to use one batch production. While applying the paint the surface must be protected from the direct sun rays and excess wetting (rain, fog).

Consumption of interior acrylic paint for walls and ceilings ANSERGLOB is 0,15-0,35 kg per m2 in average.

Can be used with other our products

Related products

X

Become a reseller

Leave your contact information, we will contact you shortly to discuss cooperation

X

FORM FOAM

X

Thank you, the application has been successfully sent!
Our manager will contact you as soon as possible

X

Thanks, your order has been successfully sent!
Our manager will contact you shortly

X

I want to work in anserglob






(doc, docx, pdf)

Attach resume