ANSERGLOB EG 58

Advantages

Ecologically friendly
For interior and exterior use
Ready to use
Strengthens the base
Decreases the water sorption
Increases the adhesion to the substrate

Technical data

Drying time	2-4 hours
Film elasticity	not more than 1 mm
Density	1,0 g/cm3
Diffusion resistance	about 100µН2О
Surface temperature	from +5°С to +30°С
Exploitation temperature	from -30°С to +80°С

Consumption
calculator

Colors
catalogue

Product certificates

Deep penetrating primer ANSERGLOB EG 58 is used for treatment of mineral surfaces with strong water sorption: gypsum, drywall, cement, lime-cement and other surfaces. While deeply penetrating into the sub-strate the primer strengths it and increases the adhesion of dry-set mortar, plaster, paint and other finishing materials, levels and decreases water sorption of porous substrates, reduces consumption of paint or wallpa-per glue, provides level painting of surface, ties the dust. The primer is used for interior substrates surfaces. The film after drying is transparent.

The surface preparation is realized according to State Standard of Ukraine (DSTU N B A.3.1-23:2013) and State Building Codes of Ukraine (DBN В.2.6-22-2001). Surface must be structurally sound, clean, dry and free from dust, grease, dirt, oil or emulsion paints. Before applying the primer fragile areas of the substrate should be removed.

Applied with the roller, brush or sprayer successively covering all the surface without a skip. Treated surface must be half-matte. Depending on the quality of the surface the primer could be applied in one or two layers by “wet on wet”. The surface is ready to use after 2-4 hours of application of the last layer. When applied avoid the drying of the primer and wash the hands and tools by water.

Note: Application should be complied at temperature above +5 °С and below +30 °С. All the mentioned recom-mendations are effective at temperature of +20 °С and air humidity of 60 %. Under the other conditions dry-ing time of the primer may be changed.

Consumption of primer is 0,15-0,16 L per m2 average.