• Ecologically friendly
  • Does not destroy the surface
  • Not combustible
  • Highly
  • Does not change the color of the surface

Technical data

Density 1,05 g/cm3
Surface temperature from +5°С to +30°С
Exploitation temperature from -30°С to +80°С
The emulsion for removal efflorescence effect ANSERGLOB ES 67 SALT STOP is a universal cleaner that is used for removal from the wall surface cement, lime deposits, metal corrosion (rust), efflorescence effect and atmospheric precipitation. Its effect is based on the solution of the salts and different precipitation with aid of acids and its foregoing removal by water. It is used for cleaning the facades of brickwork, natural stone (limestone, sandstone), mortars, concrete from the efflorescence effect that appears on the surface in the result of migration of the salts from the depths of the wall at moisture evaporating, atmospheric precipi-tation and from the mortar blots. It is used for interior or exterior substrates surfaces. Keep away from con-tact with metallic tools.
The surface preparation is realized according to State Standard of Ukraine (DSTU N B A.3.1-23:2013) and State Building Codes of Ukraine (DBN В.2.6-22-2001). Surface must be structurally sound, clean, dry and free from dust, grease, dirt, oil or emulsion paints. Before applying the emulsion fragile areas of the substrate should be removed. It is recommended to make a trial cleaning.
The cleaner is applied with the brush or block brush, exposed 2-5 minutes. It should be cleaned up by pres-surized jets of water or with a brush dipped in water. If the surface is much polluted, repeat treatment is re-quired. In order to avoid wetting and repeated appearing of efflorescence effect the surface must be treated by the emulsion hydrophobizing ANSERGOB ES 66 after 24 hours.

Note: Application should be complied at temperature above +5 °С and below +30 °С. All the mentioned recom-mendations are effective at temperature of +20 °С and air humidity of 60 %. Under the other conditions dry-ing time of the emulsion may be changed.

Consumption of emulsion hydrophobizing is 0,1-0,2 L per m2 average.

Related products


Become a reseller

Leave your contact information, we will contact you shortly to discuss cooperation




Thank you, the application has been successfully sent!
Our manager will contact you as soon as possible


Thanks, your order has been successfully sent!
Our manager will contact you shortly


I want to work in anserglob

(doc, docx, pdf)

Attach resume