Emulsion fungicide ES 65 Biostop is used for removal of fungi, lichens, mosses, yeasts and other microor-ganisms. Emulsion fungicide ES 65 Biostop is applied on mineral surfaces (concrete, lime-cement, cement-sand mortars, surfaces painted by glue or dispersive paints and etc). Emulsion fungicide ES 65 Biostop is a ready to use water solution of active substances, which have a strong biocide effect. While penetrating deep into the substrate, ANSERGLOB ES 65 disinfects and sanitizes it. ANSERGLOB ES 65 Biostop can be used for interior or exterior substrates surfaces. ANSERGLOB ES 65 Biostop is ecologically friendly.
The surface preparation is realized according to State Standard of Ukraine (DSTU N B A.3.1-23:2013) and State Building Codes of Ukraine (DBN В.2.6-22-2001). The surface contaminated with fungus, lichen, moss must be cleaned mechanically. Before applying the emulsion fungicide fragile areas of the surface should be thoroughly removed. It is recommended to make a trial cleaning.
Before application the emulsion fungicide ANSERGLOB ES 65 Biostop must be thoroughly mixed. The emulsion fungicide is applied with the brush, block brush or by sponge in one or two layers successively covering all the surface without a skip. To avoid reinfection and obtain a permanent effect the surface must be treated by primer ANSERGLOB EG 69.
In case of strong surface infection by the fungus, lichen or other microorganisms should be used removal methods offered by companies that specialize in carrying out these works. When applied avoid the drying of the emulsion fungicide and wash the hands and tools by water. The treatment is carry out in latex gloves.
Note: Application should be complied at temperature above +5 °С and below +30 °С. All the mentioned recom-mendations are effective at temperature of +20 °С and air humidity of 60 %. Under the other conditions dry-ing time of the primer may be changed.
Consumption of emulsion fungicide is 0,15-0,30 L per m2 average.
