facebook

ANSERGLOB ES 86 STONE

Advantages

  • Decreases the water sorption
  • Resistant to the pollution of the surface
  • Ecologically friendly
  • Improves pattern of the surface
  • Resistant to the UV
  • Resistant to the wet abrasion

Technical data

Drying time 3 hours
Density 1,03 g/cm3
Resistant to
atmospheric precipitation
48 hours
Surface temperature from +5°С to +30°С
Exploitation temperature from -30°С to +80°С
The silicone-acrylic lacquer ANSERGLOB ES 86 STONE is used for treating the surface of mosaic plaster, brick-work, slate roof, tile, decorative natural and artificial stone, decorative plaster interior, and exterior (including the socles) in order to improve the decorative properties of the surface, to protect the substrate from the mechanical, biological treatment and from the pollution. The lacquers acrylic ANSERGLOB ES 86 STONE after the drying forms permanent, elastic, high strength, transparent film, that improves pattern, gives the waterproof properties to the surface, increases the durability, and simplifies the care after the coating. The formed film is resistant to ultraviolet rays, moisture, and detergents. The lacquer is VOC free and ecologically friendly.
The surface preparation is realized according to State Standard of Ukraine (DSTU N B A.3.1-23:2013) and State Building Codes of Ukraine (DBN В.2.6-22-2001). Surface must be structurally sound, clean, dry and free from dust, grease, dirt, oil or emulsion paints. Before applying the lacquer fragile areas of the substrate should be removed.
Before application, the lacquer silicone - acrylic ANSERGLOB ES 86 STONE must be well mixed. The lacquer is applied with the brush, roller or pneumatic sprayer in one or two layers (that depends on surface nature). The application on the same surface is provided continuously, according to the rule “wet on wet”. The interim drying between the layers must be 2-3 hours. The dried lacquer is resistant to the mechanical treatment. When applied avoid the drying of the lacquer and wash the hands and tools by water.

Note: Application should be complied at temperature above +5 °С and below +30 °С. All the above-mentioned recommendations are effective at the temperature of +20 °С and air humidity of 60 %. Under the other conditions, drying time of the primer may be changed. While applying the surface must be protected from the direct sun rays and also from the excess humidity (rain, fog).

Consumption of lacquer is 0,15-0,2 L per m2 average.

Related products

X

Become a reseller

Leave your contact information, we will contact you shortly to discuss cooperation

X

FORM FOAM

X

Thank you, the application has been successfully sent!
Our manager will contact you as soon as possible

X

Thanks, your order has been successfully sent!
Our manager will contact you shortly

X

I want to work in anserglob






(doc, docx, pdf)

Attach resume