ANSERGLOB TMS 130

Advantages

  • Permeable
  • Freezeproof
  • Ecologically friendly
  • Resistant to weather
  • Mineral
  • For interior and exterior use
  • Damage resistant
  • 50 square meters
  • Machine application

Technical data

Thickness of layer 0,8 - 5,0 mm
Mixture ratio 0,21 – 0,22  l per kg of mixture
Adjustment time not less than 2 hours
Adhesion to the substrate not less than 0,5 MPa
Freeze-Thaw Stability not less than 75 cycles
Water-vapor permeability not less than 0,05 mg/m∙g∙Pa
Surface temperature from +5°С to +30°С
Water absorption coefficient  not more than 0.5 kg / m² √h
Exploitation temperature from -30°С to +80°С
Decorative laster ANSERGLOB TMS 130 structural white (for paint overcoating) is used to create the decorative thinlayer plastering as interior as exterior walls of buildings and also in the exterior insulation finishing system ANSERGLOB. It is applied on any mineral substrates (cement, cement-lime, gypsum plasters and etc.). It is recommended for decorative finishing of facades and interiors with creation of various textures, has a high rate of whiteness.
Preparation of the base is carried out in accordance with DSTU - N B A.3.1-23: 2013 and DSTU-N B V.2.6-212: 2016. The base must be strong, free from dust, dirt, lime, grease, oil or emulsion paints. During repair work, before applying the plaster, it is necessary to carefully remove the fragile areas of the base. Smooth surface irregularities up to 4 mm with ANSERGLOB VST 27 finishing filler, large wall irregularities with ANSERGLOB VST 20 plaster mortar. Depending on the water absorption, treat the substrates with one of the ANSERGLOB primers and allow the required time to dry.
For machine application, the operating pressure of 3.5 - 4.5 atm is set on the air supply compressor. The container of the spray gun is filled with the prepared mortar mixture. Then, using a spray gun (nozzle diameter 4-8 mm), the mixture is sprayed onto the prepared surface until the desired texture is obtained, which depends on the air supply and the consistency of the mixture and the diameter of the outlet nozzle. The mixture is poured onto the surface to the desired spray pattern. When 5 - 45 minutes have elapsed after application, if necessary, the surface is smoothed with a metal stainless steel trowel to the desired texture. The time until the start of smoothing depends on the weather conditions, the presence of drafts and direct sunlight. After finishing work, as well as during breaks in work, the tool and equipment must be cleaned of the solution and washed thoroughly. Freshly applied mixture must be protected from rain, overheating and direct sunlight. After 3 days, the surface is ready for painting with water-based paints, 7 days with paints based on organic solvents.
0,5 kg/ sq m
The dry mixture must be filled into a container with clean water at the rate of 0.21 - 0.22 liters of water per 1 kg of mixture (5.25 - 5.5 liters of water per bag of 25 kg) while stirring manually or mechanically with a drill at low speed ) to obtain a homogeneous mass. After 5 minutes, the mixture must be stirred again, after which it can be used for 2 hours.

Can be used with other our products

Related products

X

Become a reseller

Leave your contact information, we will contact you shortly to discuss cooperation

X

FORM FOAM

X

Thank you, the application has been successfully sent!
Our manager will contact you as soon as possible

X

Thanks, your order has been successfully sent!
Our manager will contact you shortly

X

I want to work in anserglob






(doc, docx, pdf)

Attach resume