Adhesive foam ANSERGLOB PRO FIX is intended for fastening of insulating plates and panels (EPS, XPS, MW, PIR, PUR, stoppers, etc.) to almost all construction products, materials, designs made of concrete, aerated concrete, plaster, brick , metal, wood, glass, PVC, etc. Also for installation of gypsum cardboard, fiber cement panels, ceramic tiles and natural stone. It is used for joints of building, insulating structures with decorative elements made of wood, plastic, etc .. Adhesive foam ANSERGLOB PRO FIX is used indoors and outdoors. It is intended for vertical and horizontal pasting.
Preparation of the basis is carried out according to DSTU - N B A.3.1-23: 2013. The base must be dry and strong, free from dust, dirt, grease, oil or emulsion paints. The surface must be tested for adhesive properties before applying the foam. In some cases, if the surface has hydrophobic properties, it needs to be mechanically roughened to improve adhesion. In addition, it is necessary to protect surfaces that may accidentally get foam. The surface must be moistened before applying the adhesive foam.
Adhesive foam must be applied with a mounting gun. To do this, place the cylinder valve up and fasten the gun to it. After fixing the cylinder, it should be carefully shaken and placed upside down on the mountain. Application on the thermal insulation board is carried out in strips of 2-3 cm. Wait 1 minute after application and connect the gluing elements, but not later than 5 minutes. The amount of foam output is regulated by a pistol hook. If large surfaces (such as GCL) are glued together, the foam must cover at least 5% of the surface. The recommended seam thickness is 5 mm. To remove fresh, not hardened Adhesive foam, as well as to clean the tool, you must use a special cleaner. After hardening of Adhesive foam it is necessary to protect it from UV radiation by means of plaster, putty or ANSERGLOB paint. The open balloon should be used within a week.
Consumption of Adhesive foam - up to 40 m (with a strip of 2-3 cm). Enough for thermal insulation from 6 to 14 м2 (depending on temperature, humidity, application thickness and skills of the contractor).